Epson SC-F9200 Series Service Manual page 206

SC-F9200 Series
3.4.5.23 IM Sensor
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p260)
perform the specified operations including required adjustment.
When replacing the IM Sensor, make sure to replace the PW
C H E C K
P O I N T Sensor, too.
(p98)
1. Unlock the CR Unit.
2. Remove the Left Rear Cover. (p110)
(p111)
3. Remove the Left Upper Cover.
(p139)
4. Remove the CR Cover.
5. Move the CR Unit to the left end.
6. Remove the Sensor Cover. (See Step 6
204)
)
7. Disconnect the FFC from the connector of the IM Sensor, and remove the IM
Sensor.
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
"3.4.5.22 PW Sensor" (P.
to Step 7 in
Disassembly and Assembly Procedure
Before installing the IM Sensor to the CR Unit, insert its protruded
portion into the groove of the Sensor Cover.
Should be engaged like this
Sensor Cover
- Bottom of the CR Unit -
IM Sensor
FFC
Figure 3-150. Removing the IM Sensor
SE Group Confidential (Related Staff Only)
Revision B
IM Sensor
206