Epson SC-F9200 Series Service Manual page 363

SC-F9200 Series
C H E C K
The following procedure is described for the case of -5 mm
P O I N T
deformation.
4. Loosen the three screws at home side.
Home side
Screw
Screw
Screw
Figure 4-87. AH Standard Adjustment (1)
5. Lift the bottom of the Heater Frame by 10 mm.
Figure 4-88. AH Standard Adjustment (2)
ADJUSTMENT
x
Heater Frame
Other Printer Checks and Adjustments
6. Attach the shims: two to screw (1) and four to screw (2).
7. Tighten the three screws.
Home side
Screw
Screw (1)
Screw (2)
Figure 4-89. AH Standard Adjustment (3)
8. Install the Sub-E Board Cover.
9. Install the After Heater.
10. Measure the amount of deformation.

If the amount is between -2 to -1 mm: End of the adjustment.

If the amount is between -2.9 to -2.1 mm or between 1.1 mm to 1.9 mm:
Perform the AH Position Adjustment
SE Group Confidential (Related Staff Only)
Revision C
Shim
Shim
Heater Frame
(P. 364).
363