Epson SC-F9200 Series Service Manual page 217

SC-F9200 Series
3.4.6.7 PF Timing Belt
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p260)
perform the specified operations including required adjustment.
(p110)
1. Remove the Left Rear Cover.
(p111)
2. Remove the Left Upper Cover.
(p114)
3. Remove the Left Cover.
4. Loosen the two screws (A) that secure the PF Motor Mounting Plate.
Before tightening the screw A, move the PF Motor Mounting Plate
frontward and rearward several times, and make sure that the
plate moves smoothly and tension of the tension spring is applied
properly.
5. While pressing the mounting plate in the direction of the arrow, loosen the tension
of the PF Timing Belt, and remove the belt from the pinion gear of the PF Motor.
6. Disconnect the FFC from the PF Encoder, and release the FFC from the PF
Encoder Holder.
Make sure to route the FFC through the pins of the PF Encoder
Holder.
7. Remove the PF Timing Belt.
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
Disassembly and Assembly Procedure
PF Timing Belt
A
A
Pinion gear
PF Motor Mounting Plate
Figure 3-167. Removing the PF Timing Belt
SE Group Confidential (Related Staff Only)
Revision B
FFC
PF Encoder
PF Encoder Holder
Route the cable
217