Epson SC-F9200 Series Service Manual page 59

SC-F9200 Series
Code Error Name
Reel Motor The control terminal (Vre terminal) of the Reel Motor
15A9
oscillation error driver has shorted out.
Overcurrent to the Reel Motor was detected.

Reel Motor cable disconnection.
Reel Motor
15AA 
Irregular load
overload error

Reel Motor encoder failure

Reel Motor failure
The Reel Motor was driven at a speed faster than a
predetermined one during deceleration.

Irregular load
Reel Motor
15AB

over speed error
Reel Motor encoder failure

Sub-F Board failure

Reel Motor driver failure
The number of occurrences of reversing the Reel
Motor has reached a predetermined limit.
Reel Motor
15AC
reversing error 
The polarity of Reel Motor cable is opposite.

Reel Motor failure
Abnormally-long driving duration of the Reel Motor
was detected.
Reel Motor
15AD

driving time-out error Irregular load

Firmware becomes out of control.
TROUBLE SHOOTING
Table 2-4. Troubleshooting for Service Call Error
Cause
1. Is the Reel Motor driver on the Main Board
damaged?
2. Is there any foreign materials around the Reel
Motor driver?
1. Is there any problems such as damaged cable in the
connections below?

Reel Motor to Sub-F Board (CN601)
2. Does the Reel Motor encoder work properly?
Check it using the Service Program.
Does the Reel Motor encoder work properly? Check it
using the Service Program.
1. Is there any problems such as damaged cable in the
connections below?

Reel Motor to Sub-F Board (CN601)
2. Does the Reel Motor encoder work properly?
Check it using the Service Program.
Remedies for Service Call Error
Check Item
1. Remove the foreign material.
2. If the error still occurs, replace the Main Board.
(Page 123)
Replace the Reel Motor.
1. Replace the Reel Motor.
2. Replace the Sub-F Board.
3. Replace the Main Board.
Replace the Reel Motor.
--- Replace the Main Board.
SE Group Confidential (Related Staff Only)
Revision C
Remedy
(Page 249)
(Page 249)
(Page 247)
(Page 123)
(Page 249)
(Page 123)
59