Epson SC-F9200 Series Service Manual page 320

SC-F9200 Series
(P. 139)
8. Remove the CR Cover.
9. Loosen the screw that secures the Adjustment Knob.
Be careful not to completely remove the screw that secures the
C A U T I O N
Adjustment Knob.
10. Move the Adjustment Knob to correct the head slant.
See Figure 4-41 for which direction to move the knob.
Screw
Plus direction
Figure 4-41. Correcting the Head Slant
ADJUSTMENT
Adjustment Knob
Minus direction
Head Related Checks and Adjustments
11. Tighten the screw to secure the Adjustment Knob.
12. Print the pattern and see if the slant is corrected. If not, repeat the procedure until
normal pattern is printed.
C H E C K
When the result does not fall within the adjustable range if you try
P O I N T
it a few times, perform the PG Adjustment
again.
13. When finished, click [Finish] and turn the printer OFF.
Rear Front
Condition of the head
Paper feed direction
Printed pattern
Rear Front
Adjustment knob
Print Head
Figure 4-42. Adjustment
SE Group Confidential (Related Staff Only)
Revision C
(P. 306) first and try
x
Rear Front
Rear Front
Print Head
320