Epson SC-F9200 Series Service Manual page 125

SC-F9200 Series
3.4.4.3 PSH Board/PSH-B Board
When replacing/removing this part, refer to
A D J U S T M E N T
R E Q U I R E D
Items and the Order by Repaired Part" (p260)
perform the specified operations including required adjustment.
Always replace the two Power Supply Boards (PSH Board and
C A U T I O N
PSH-B Board) at the same time.
(p117)
1. Remove the Board Box Cover.
2. Remove the four screws and remove the Board Right Frame.
A) Silver M3x6 screw: 4 pcs
- Right side -
Figure 3-49. Removing the Board Right Frame
DISASSEMBLY & ASSEMBLY
"4.1.2 Adjustment
and make sure to
A
A
Board Right Frame
A
A
Disassembly and Assembly Procedure
3. Remove the two screws, and remove the shield plate.
B) Silver M3x6 screw: 2 pcs
- Right side -
B
Shield plate
B
Figure 3-50. Removing the shield plate
SE Group Confidential (Related Staff Only)
Revision B
Power Supply
Board Box
125