OPTIONS
2-58
17.
Connect the D-connector attached to your drop
cable to the connector on the XC 24 Network
Access Board (Fig. 2-15).
~
Note:
Contact your site planner or network
coordinator if you need to have a drop cable
installed.
Figure 2-15. Connect a D-connector to the XC 24 Network
Access Board.
18. Return to Section 1, Installation, to finish
installing your system.
If you added an XC 24 Network Access Board to
a system that was already set up:
Connect all plugs to the back of the
processor.
Connect the power cord.
• Turn the system on.
OPTIONS