Inserting Your Diagnostics Disk - Xerox 6060 Hardware Installation And Facts

DIAGNOSTICS
Inserting Your Diagnostics Disk
4-2
1.
Find the disk labeled DIAGNOSTIC DISK in
~
the software disk box. '
2.
Also obtain two blank (or erasable) floppy
disks.
3.
Remove the Diagnostic Disk from its jacket and
check to see that it is protected by a write-
protect tape, as shown in Fig. 4-1.
Figure 4-1. Be sure the write/protect
tape
is on.
Compare the floppy disk drive(s) on your processor
with the illustrations below.
(If
your system has a
hard disk, it will have only one floppy drive.)
Figure 4-2. Illustration of floppy disk drives.
4.
Open your floppy disk drive(s) by turning the
disk drive lever up and to the right.
DIAGNOSTICS