Xerox 6060 Hardware Installation And Facts page 63

OPTIONS
OPTIONS
8.
Slide switch 5 to the OFF position. To change
the switch setting, use the tip of a ball point pen
or small screwdriver to push the switch lever
into the other position. Do not move any other
switches.
Note: If you're installinJ other options, you
may need to make additional changes to the
processor board. Check the instructions for
your other options to see if additional changes
are required before you replace the bottom
cover.
Reset Button
Figure 2-8. Replacing the bottom cover.
9.
Replace the bottom cover of the processor.
- Position the front of the cover over the
RESET button
CAREFULLY
to avoid
damaging it.
- Slide the cover toward the rear of the
processor until it is in place. Be sure that the
edges of the cover fit over the processor
frame.
- Tighten the two screws to secure the bottom
cover.
IO.Return to Section 1., Installation, page 1-7 to
finish installing your system.
2-31