Xerox 6060 Hardware Installation And Facts page 84

OPTIONS
2-52
Press down firmly on the center of the
jumper block until it is seated. Be sure all
pins are inserted before continuing.
5.
If you're adding an XC 24 Network Access
Board to a system that is already set up:
BE SURE the computer's power switch is OFF.
Unplug the power cord.
• Check that the power switches on your printer
and other devices are OFF.
Disconnect all plugs from the back of the
processor.
6.
Loosen the two screws securing the top cover of
the processor. (The screws do not come all the
way out.)
Figure 2-7. Location of
top
co11er screws
7.
Remove the processor's top cover.
Stand facing the back of the processor.
..
__
.,...
Place your hands on the top cover. Applying
pressure with both hands, give one quick
push away from you. The processor cover ~
will move away from the back panel about
.l."
...
OPTIONS