Xerox 6060 Hardware Installation And Facts page 77

OPTIONS
OPTIONS
5.
Position the DIP switches.
Look at your DIP switches to determine
which way is ON. (There may be a very
small ON somewhere on the switch. ON
may also be represented by the number 1 or
an up arrow, and OFF, by
0.)
Use the tip of a ball-point pen or small
screwdriver to change your switch settings.
6.
Locate the position for the board.
Note: Because the ASA Communications Adapter
Board has only one edge connector, it should be
inserted into the first available single row socket to
the right.
option slot plate
Figure 2-3. Location for the board.
7. Remove the screw and the option slot plate and
set them aside. See Fig. 2-3.
2-45