Xerox 6060 Hardware Installation And Facts page 72

OPTIONS
2-40
5.
Position the DIP switches.
Look at your DIP switches to determine
which way is ON. (There may be a very
~
small ON somewhere on the switch. ON
may also be represented by an up arrow or by -..___.,,
the number 1, and OFF, by
0.)
Use the tip of a ball-point pen or small
screwdriver to change your switch settings.
6.
Locate the position for the coax option board.
Because the coax option board has only one edge
connector, it should be inserted into the first
available single row socket to the right.
option slot plate
Figure 2-3. Location for coax option board.
7.
Remove the screw and the option slot plate and
set them aside. See Fig. 2-3.
8.
Locate the two wires connected to the back left
corner of the processor. Gently move the wires
~
back out of the way so you can insert the coax
option board as shown in Fig. 2-4 on the next
page.
OPTIONS