Xerox 6060 Hardware Installation And Facts page 78

OPTIONS
2-46
Figure 2-4. I nst.alling the board.
Single Edge Connectoh.
Single Edge Socket -.._,
8.
Locate the two wires connected to the back left
corner of the processor. If they cross the socket
where you will be inserting the board, gently
move them out of the way.
9.
Insert the edge connector into the socket andr'\
press down firmly until the board "snaps" into
place.
10.
Secure the ASA Communications Adapter
Board in the slot with the screw removed
earlier.
11.
Replace the top cover of the processor as
follows:
• Lower the front of the cover into place. Press
in on the sides of the cover as you lower them
into place, making sure the cover edges fit
inside the processor frame. See Fig. 2-5.
• With hands pressing firmly against the sides
of the cover, give one quick pull toward the
rear of the processor. Make sure the sides
stay inside the processor frame. ( \
• Tighten the two screws on the back to secure
the top cover.
OPTIONS