Running Diagnostics - Xerox 6060 Hardware Installation And Facts

DIAGNOSTICS
Running Diagnostics
DIAGNOSTICS
1.
Start with the system turned on.
Turn on your printer first.
Turn on your processor.
2. Insert the Diagnostic Disk in the bottom (A)
disk drive. (See illustrations on page 4-3.)
If the system has just been turned on,
diagnostics will start running.
If the system has other software loaded,
press the RESET button on the front of the
processor.
The following will display:
The XEROX Personal Computer MS-DOS
Release 1.0 - Created 2/19/85 vr .59
Microsoft MS-DOS version 2.11
Copyright 1981,82,83 Microsoft Corp.
Command v.2.11
A> customer
After a few seconds, the message below will
also appear:
TO EXIT CUSTOMER TEST PROGRAM DURING TESTING,
PRESS THE 'ctrl-break' KEYS
DO YOU WISH TO RUN THE TESTS IN AUTOMATIC MODE?
('O'
= NO, '1' = YES)
4-7