Polycom Microphone Lights; Connecting Non-Polycom Microphones Or A Mixer To A; Polycom Hdx System - Polycom HDX 4000 Series Administrator's Manual

Polycom Microphone Lights

Connecting Non-Polycom Microphones or a Mixer to a

Polycom HDX System

Polycom, Inc.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Left and right channel assignments depend on the settings that you select on
the Stereo Settings screen. If Autorotation is enabled for a microphone, the
system automatically assigns active channels for the microphone. Make sure
that microphones with Autorotation disabled are oriented as shown in the
following illustration.
After you place the microphones, you will need to configure the system to
send stereo as described in
The following table describes the behavior of the microphone lights on a
Polycom HDX table microphone.
Microphone Light Status
Off Not in a call
Green In a call, mute off
Red Mute on
Amber Firmware upload
You can connect non-Polycom microphones directly to audio input 1 on a
Polycom HDX 9004, Polycom HDX 9002, or Polycom HDX 9001 system, or
through a line-level mixer to the AUX audio input on any Polycom HDX 9000
series, Polycom HDX 8000 series, or Polycom HDX 7000 series system. For
more information about configuring these non-Polycom microphones, refer to
Settings for Non-Polycom Microphones
You can connect several microphones to a Polycom HDX 9000 series, Polycom
HDX 8000 series, Polycom HDX 7000 series, or Polycom HDX 6000 series
system through a Polycom audio mixer. The SoundStructure C-Series mixer
connects to the digital microphone connector on a Polycom HDX system, and
no configuration is necessary.
StereoSurround Settings on page 4-18.
on page 4-21.
Microphones and Speakers
4–9