Configuring The Polycom Touch Control Lan Properties - Polycom HDX 4000 Series Administrator's Manual

Polycom, Inc.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting Description
Generates an ICMP Destination Unreachable message if
Generate
Destination a packet cannot be delivered to its destination for reasons
Unreachable other than network congestion.
Messages
Sends an ICMP Echo Reply message in response to a
Respond to
Broadcast and broadcast or multicast Echo Request, which is not
Multicast Echo specifically addressed to the HDX system.
Requests
IPv6 DAD Specifies the number of Duplicate Address Detection (DAD)
Transmit Count messages to transmit before acquiring an IPv6 address. The
HDX system sends DAD messages to determine whether
the address it is requesting is already in use.
Select whether to transmit 0, 1, 2, or 3 DAD requests for an
IPv6 address.

Configuring the Polycom Touch Control LAN Properties

To configure Polycom Touch Control LAN settings:
From the Home screen, touch
1
Touch the LAN Properties tab.
2
Configure the following IP Address (IPv4) settings:
3
Setting Description
Set IP Specifies how the Touch Control obtains an IP address.
Address
• Obtain IP address automatically — Select if the Touch
Control gets an IP address from the DHCP server on the LAN.
• Enter IP address manually — Select if the IP address is not
automatically assigned.
IP Address Displays the IP address currently assigned to the Touch Control, if
the Touch Control obtains its IP address automatically.
If you selected Enter IP address manually, enter the IP address
here.
Subnet Mask Displays the subnet mask currently assigned to the Touch Control.
If you selected Enter IP address manually, enter the subnet
mask here.
Default Displays the gateway currently assigned to the Touch Control.
Gateway
If you selected Enter IP address manually, enter the gateway IP
address here.
Administration.
Networks
2–7