Polycom HDX 4000 Series Administrator's Manual page 104

Polycom, Inc.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting Description
Horizontal Position, Adjusts the VGA Input settings.
Phase, Vertical
1
Position
Polycom HDX 9004
2
Polycom HDX 9002
Polycom HDX 9001
Polycom HDX 6000 HD
3
Camera 5 Resolution and aspect ratio are detected automatically.
Polycom HDX 9004
Name Specifies a name and icon for the computer or video
source.
Polycom HDX 9004
Note: If your HDX system is paired with a Polycom
Touch Control and you change a camera icon on the
HDX system, the Touch Control continues to show the
default icon.
Source Specifies whether the video source is People or
Content. Video sources specified as Content are sent
Polycom HDX 9004
at a higher resolution and lower frame rate.
Video Quality Specifies Motion or Sharpness for the video input.
Polycom HDX 9004
•
•
Detect Camera Detects any supported PTZ camera connected to
Polycom HDX system video input 5, and configures the
Polycom HDX 9004
camera settings accordingly. This button appears only
when RS-232 Mode is set to Camera PTZ and Camera
Control is set to Camera 5 for one of the serial ports.
Horizontal Position, Adjusts the VGA Input settings.
Phase, Vertical
1
Position
Polycom HDX 9004
2
3
Far Control of Near Specifies whether the far site can pan, tilt, or zoom the
Camera or Far End near-site camera. When this option is selected, a user
Camera Control at the far site can control the framing and angle of the
(FECC) camera for the best view of the near site.
Select Horizontal Position, Phase, or Vertical
Position.
Adjust the settings using the remote control or the
web interface.
Press Back on the remote control to accept the
setting or select Update in the web interface.
Motion — This setting is for showing people or
other video with motion.
Sharpness — The picture will be sharp and clear,
but motion will not be smooth. Choose this setting
for document cameras. Sharpness is available in
point-to-point H.263 calls only.
Select Horizontal Position, Phase, or Vertical
Position.
Adjust the settings using the remote control or the
web interface.
Press Back on the remote control to accept the
setting or select Update in the web interface.
Monitors and Cameras
3–29