Configuring The Pri Network Interface - Polycom HDX 4000 Series Administrator's Manual

Configuring the PRI Network Interface

Polycom, Inc.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
If you have configured the ISDN switch protocol to be AT&T 5ESS
3
Multipoint, NI-1, NI-2, or Nortel DMS-100, select
enter the ISDN BRI SPIDs provided by your service provider.
After you enter the SPIDs, the system verifies them. If the system is unable
to verify the SPIDs, make sure the system is connected and that the ISDN
numbers you entered are correct.
If you do not have the SPIDs from your service provider, you can click
Start to Auto Detect SPIDs.
Points to note about fractional PRI:
• Assigned channels must begin with channel 1, and the channel numbers must
be consecutive.
• A D channel must be provided.
• Outbound call bandwidth must not exceed the available bandwidth.
To configure the ISDN network interface settings:
Do one of the following:
1
— In the local interface, go to System > Admin Settings > Network >
ISDN (select if necessary).
— In the web interface, go to Admin Settings > Network > ISDN.
Configure these settings:
2
Setting Description
Enable ISDN Allows this system to make H.320 (ISDN) calls.
H.320
Area Code Specifies the area code for this system's location.
PRI Video Specifies the ISDN number assigned to this system.
Number
Outside Line Specifies the ISDN dialing prefix used to call outside the
Dialing Prefix network.
BONDING: Specifies the use of a bonding standard. Incoming bonded
calls will use the original number received to connect all
Calling Endpoint
remaining lines required for the call.
Uses the Original
ISDN Number
Line Signaling Specifies the framing format in use.
This setting is configurable for PRI E1, read-only for PRI T1.
Networks
if necessary and
2–31