Power-On Self Test (Post); Powering On The Polycom Hdx 9000 Series Systems - Polycom HDX 4000 Series Administrator's Manual

Power-On Self Test (POST)

Powering On the Polycom HDX 9000 Series Systems

Polycom, Inc.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The Power button affects any HDX system within the range of the remote
control, regardless of the Channel ID setting.
For instructions on how to power on and off the Polycom Touch Control, refer
to Powering On the Polycom Touch Control Device
After the splash screen is displayed, the HDX system automatically performs
system health checks every time the system starts. As each check begins, a
message appears on Monitor 1.
If a test fails, press Hangup
process. However, even if the system appears to start up, Polycom
recommends that you contact Technical Support before using your HDX
system if any system tests fail.
To power on the Polycom HDX 9000 series, do one of the following:
• Press the power button on the remote control.
• Press the power switch on the front of the system.
The Polycom splash screen is displayed within about 10 seconds.
To power off the Polycom HDX 9000 series, do one of the following:
• Press and hold the
• Press and hold the power switch on the front of the system for 2 seconds.
After turning the power off in this way, wait at least 15 seconds before you
unplug the system from its power source.
Introducing the Polycom HDX Systems
on page 1-15.
on the remote control to continue the startup
power button on the remote control for 2 seconds.
1–9