Connecting Cameras; Polycom Eagleeye Hd - Polycom HDX 4000 Series Administrator's Manual

Connecting Cameras

Polycom EagleEye HD

Polycom, Inc.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
• To keep the screen clear of static images during a call, disable the
following settings:
— Display Icons in a Call. For more information, refer to the settings
table described in
— Display Time in Call. For more information, refer to the settings table
described in Configuring Call Settings
— Far Site Name Display Time. For more information, refer to the
settings table described in
• Be aware that meetings that last more than an hour without much
movement can have the same effect as a static image.
• Consider decreasing the monitor's sharpness, brightness, and contrast
settings if they are set to their maximum values.
Polycom HDX 9000 series, Polycom HDX 8000 series, and Polycom HDX 7000
series systems provide inputs for multiple PTZ cameras. You can use the
RS-232 serial port on the system to control supported non-Polycom cameras or
cameras not connected to a main camera input.
Polycom HDX 8000 series, Polycom HDX 7000 series, and Polycom HDX 6000
series systems must be connected to a camera with an IR receiver to receive
signals from the remote control. Be sure to point the remote control at the
camera to control those Polycom HDX systems. Refer to the "Interoperability"
section of the current HDX system release notes for a list of supported cameras
with IR receivers.
If you use a Sony RS-232 cable for PTZ control of a Sony camera, the built-in IR
receiver might not map to the correct pin on the Polycom HDCI Breakout adapter. If
you experience this problem, use the Polycom HDX HDCI-Sony cable to get the
correct mapping.
You can use the Polycom EagleEye™ HD camera with all Polycom HDX
systems. Polycom EagleEye HD cameras provide 720p resolution.
When connecting a Polycom EagleEye HD camera to video input 2 on a Polycom
HDX 9000 series or Polycom HDX 8000 series system, use only the approved
Polycom UL Listed adaptor, Class 2 or LPS not exceeding 12 Volts, 3.33 Amps
(part number 1465-52733-040). Verify the polarity of the power supply as shown on
the Polycom camera next to the power supply input.
Configuring Monitor Settings
on page 6-1.
Configuring Call Settings
Monitors and Cameras
on page 3-3.
on page 6-1.
3–15