Using Telnet To Enable Smartpairing - Polycom HDX 4000 Series Administrator's Manual

Administrator's Guide for Polycom HDX Systems

Using Telnet to Enable SmartPairing

10–12
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Security Profile
Maximum, High
Medium, Low, Minimum
To enable SmartPairing, follow these steps:
On the computer, open a command line interface.
1
Start a Telnet session using the Polycom HDX system's IP address and
2
port number — for example, telnet 10.11.12.13 24.
Log in and enter your user name or password, if required.
3
Type the following to enable SmartPairing:
4
systemsetting uspairingenabled auto
SmartPairing in automatic mode is enabled.
You can use the following parameters with the systemsetting
uspairingenabled command.
SmartPairing Available
SmartPairing is not allowed
To enable SmartPairing, do the following:
Admin Settings >
• Clear the checkbox at
General Settings > Security > Security
Settings > Security Mode.
Admin Settings >
• Select the checkbox at
General Settings > Security > Security
Settings > Enable Remote Access >
Telnet.
systemsetting
• Use the API command
uspairingenabled
to enable
SmartPairing. For command line syntax
information, see Using Telnet to Enable
SmartPairing on page 10-12.
Polycom, Inc.