Chapter 5: Ethernet module configuration
Configure an Ethernet port to ensure proper operation and optimum performance of the port.
•
Enabling a module
•
Disabling a module
•
Configuring 10/100/1000 Mbit/s 9048GT Ethernet ports with Autonegotiation
•
Configuring 9048GT Ethernet ports without Autonegotiation
•
Configuring 100/1000 Mbit/s 9048GB Ethernet ports
•
Configuring 10 Gb/s 9024XL Ethernet ports
•
Associating a port to a VRF instance
Enabling a module
Prerequisites
You must log on to the Global Configuration mode in ACLI.
Enable an Ethernet module to allow traffic to flow through it.
Enable a module:
no slot shutdown {slot[-slot][,...]}
Variable definitions
Use the data in the following table to use the no shutdown slot command.
Table 5: Variable definitions
{slot[-slot][,...]}
Configuration — Ethernet Modules
using ACLI
on page 25
on page 26
on page 33
Variable
on page 28
on page 29
on page 32
Value
Specifies one or more slot numbers.
on page 26
June 2011
25