Chrysler Concorde 2004 Service Manual page 23

FEATURE DEFAULT
Rolling Door Enabled
Locks
RKE-Horn Enabled
Chirp
RKE-Rear Press Twice
Release Tog-
gle
RKE Pro- Not Applica-
gram New ble
FOB (Using
an already
programmed
FOB)
PROGRAMMING METHOD
Close all doors
Place vehicle key in the ignition and cycle
between off and run four times ending in
the off position
Customer depresses the driver power door
lock switch to lock the doors
Body Controller will toggle the enable/
disable state of rolling locks
Continually press the lock button for a
minimum of 4 seconds to a maximum of
10 seconds
Within the 4-10 second range, press the
unlock button while continuing to press
the lock button
Release both buttons
Body Controller will toggle on/off state of
horn chirp feature
Continually press the unlock button for a
minimum of 4 seconds to a maximum of
10 seconds
Within the 4-10 second range, press the
rear release button while continuing to
press the unlock buttons
Release both buttons
RKE will toggle state of one press/two
press rear release
Turn vehicle ignition switch on. With pro-
grammed FOB continually press the un-
lock button for a minimum of 4 seconds to
a maximum of 10 seconds
Within the 4-10 second range, press the
panic button while continuing to press the
unlock button
Release both buttons
Press any button of FOB(s) to be Learned.
(Note: RKE system erases all FOBs when
program mode is entered So any existing
FOBs must also be Programmed.
7
GENERAL INFORMATION
FEEDBACK
BCM provides a single
chime to indicate comple-
tion of the programming
None
BCM will sound a second
chime when programming
mode is started
BCM will sound a second
chime after each FOB has
been learned, a 32 second
time out period has
elapsed, or the vehicle igni-
tion has been turned off
Turn off ignition or wait for
32 seconds to exit seconds
to exit programming mode