Table of Contents
Advertisement
ECUs
Reconnect the battery (
Perform the TPMS ECU Cycle with the DEIS tester.
Replacing the power steering system ECU
Tightening torque
Fastening the power steering ECU
Fastening the reinforcement plate
Located behind the driver side reinforcement plate.
Disconnect the battery (
Remove the mats (
Remove the pedal mat.
F2.01).
Screw
Screw
F2.01).
E4.05).
Undo the screws indicated.
Remove the reinforcement plate (1).
Turn the reinforcement plate (1) over.
Disconnect the connector (2).
Undo the screws indicated.
Remove the power steering ECU (A) and replace.
Fit the new power steering ECU (A) in the relative
seat.
Tighten the screws indicated.
Tightening torque
Screw
Connect the connector (2).
Page 13 of 24
Nm
Class
5 Nm
B
5 Nm
B
Nm
Class
5 Nm
B
Advertisement
Table of Contents
