Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Parameter
Section 5.40
Managing IP Addresses for Routable Interfaces
The following sections describe how to configure and manage IP addresses for routable interfaces:
•
Section 5.40.1, "Configuring Costing for Routable Interfaces"
•
Section 5.40.2, "Viewing Statistics for Routable Interfaces"
•
Section 5.40.3, "Managing IPv4 Addresses"
•
Section 5.40.4, "Configuring IPv6 Neighbor Discovery"
•
Section 5.40.5, "Managing IPv6 Network Prefixes"
•
Section 5.40.6, "Managing IPv6 Addresses"
Section 5.40.1
Configuring Costing for Routable Interfaces
To configure the costing for a routable interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Set the costing by typing:
ip interface bandwidth cost
Where:
• interface is the name of the routable interface
• cost is the value used in auto-cost calculations for the routable logical interface in kbps
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.40.2
Viewing Statistics for Routable Interfaces
To view statistics for all routable interfaces, type:
show interfaces ip
A table or list similar to the following appears:
ruggedcom# show interfaces ip
interfaces ip dummy0
admin state down
state
down
pointopoint false
receive
bytes
0
packets 0
Managing IP Addresses for Routable Interfaces
Description
Based on a 10-second average.
Chapter 5
Setup and Configuration
591
Advertisement
Table of Contents
Troubleshooting
