Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Parameter
n391 { n391 }
n392 { n392 }
n393 { n393 }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 3.23.14
Managing Data Links for Frame Relay Connections
Before data can be forwarded over a Frame Relay connection to a remote destination, links to link-local virtual
circuits must be configured.
The following sections describe how to configure and manage data links for a Frame Relay connection:
•
Section 3.23.14.1, "Viewing a List of Data Links"
•
Section 3.23.14.2, "Adding a Data Link"
•
Section 3.23.14.3, "Deleting a Data Link"
Section 3.23.14.1
Viewing a List of Data Links
To view a list of data links configured for a frame relay connection, type:
show running-config interface wan interface protocol channel number connection framerelay dlci
Where:
• interface is the WAN interface
• protocol is either T1 or E1
• number is the channel number
If data links have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface wan lm2 1 t1 channel 1 connection framerelay dlci
interface
wan lm2 1
t1 channel 1
connection framerelay dlci 100
!
!
!
Managing Data Links for Frame Relay Connections
Description
Synopsis: An integer between 1 and 255
Default: 6
Defines the frequency of transmission of full status enquiry
messages. Valid for CPE.
Synopsis: An integer between 1 and 10
Default: 4
The number of error events (enumerated by n393) for which the
channel is declared inactive; valid for either cpe or Switch.
Synopsis: An integer between 1 and 10
Default: 4
The number of error events on the frame relay channel; valid for
either
cpe or switch.
Chapter 3
Device Management
143
Advertisement
Table of Contents
Troubleshooting
