Deleting A Vrf Instance; Managing Ip/Vpn Tunnels - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
intra-area { intra-area }
3. Configure prefix list filters for the VRF instance. For more information, refer to
Prefix List".
4. Configure areas for the VRF instance. For more information, refer to
5. Configure route map filters for the VRF instance. For more information, refer to
Route Map Filter".
6. Configure redistribution metrics for the VRF instance. For more information, refer to
"Adding a Redistribution
7. Configure interfaces for the VRF instance. For more information, refer to
Routing Interface".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Section 5.22.7.3

Deleting a VRF Instance

To delete a VRF instance under OSPF, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the definition key by typing:
no routing ospf vrf name
Where:
• name is the name of the VRF instance
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.22.8

Managing IP/VPN Tunnels

IP/VPN tunnels use the VPNv4 protocol to exchange customer prefixes (i.e. route distributions and route targets)
and labels between Provider Edge (PE) routers. IP/VPNs provide isolation of the interfaces connecting each end
of the VPN.
NOTE
VRF maintains a table listing each interface belonging to each IP/VPN tunnel.
The following sections describe how to configure and manage IP/VPN tunnels:
• Section 5.22.8.1, "Viewing a List of IP/VPN Tunnels"
• Section 5.22.8.2, "Adding an IP/VPN Tunnel"
• Section 5.22.8.3, "Deleting an IP/VPN Tunnels"
Deleting a VRF Instance
Description
Synopsis: An integer between 1 and 255
The administrative distance for intra-area routes.
Metric".
Setup and Configuration
Section 5.21.4.3, "Adding a
Section 5.21.5.2, "Adding an
Section 5.21.6.3, "Adding a
Section 5.21.8.2,
Section 5.21.9.2, "Configuring a
Chapter 5
Area".
389