Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
Parameter
mtu { mtu }
4.
Add one or more VLANs for the HDLC-ETH connection. For more information, refer to
"Adding an HDLC-ETH
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 3.23.11
Configuring a Multi Link PPP Connection
To configure a Multi Link Point-to-Point Protocol (MLPPP) connection for a T1 or E1 line, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to interface » wan » {interface} » {protocol} » channel » {number} , where {interface} is the
WAN interface, {parameter} is either T1 or E1, and {number} is the channel number.
3.
Configure the following parameter(s) as required:
Parameter
bundle { bundle }
on-demand
mtu { mtu }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 3.23.12
Configuring a PPP Connection
To configure a Point-to-Point Protocol (PPP) connection, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Depending on the WAN module, navigate to either:
• For T1/E1 Lines
interface » wan » {interface} » {protocol} » channel » {number} » connection, where {interface} is the
WAN interface, {parameter} is either T1 or E1, and {number} is the channel number.
• For DDS
interface » wan » {interface} » dds » connection, where {interface} is the WAN interface, {parameter} is
either T1 or E1, and {number} is the channel number.
Configuring a Multi Link PPP Connection
VLAN".
Description
Synopsis: An integer between 256 and 1500
Default: 1500
Maximum transmission unit (largest packet size allowed for this
interface).
Description
Synopsis: An integer between 1 and 50
Default: 1
The bundle number
Synopsis: typeless
This interface is up or down on demand of link fail over.
Synopsis: An integer between 256 and 1500
Default: 1500
Maximum transmission unit (largest packet size allowed for this
interface).
Chapter 3
Device Management
Section 5.37.6.2,
141
Advertisement
Table of Contents
Troubleshooting
