Table of Contents
Advertisement
Chapter 4
System Administration
connection and {end} is the either the left (local router) or right (remote router) connection end. Type must be set
to rsasig to display the public key.
The public key can be copied from the System Public Key form and added to another RUGGEDCOM ROX II
device, as described in the following procedure, or to a RUGGEDCOM ROX device.
To add an IPSec-formatted public key and have it converted into PEM format, do the following:
1.
Make sure the desired public key has been added. For more information about adding a public key, refer to
Section 4.7.3.2, "Adding a Public
2.
Enable auto-wizard by typing:
autowizard true
3.
Make sure the CLI is in Configuration mode.
4.
Type the following command:
security crypto public-key name add-ipsec-formatted-public-key content
Where:
• name is the name of the public key
The CLI enters multi-line mode.
Enter the contents of the public key, pressing Enter for each new line. When finished, press Ctrl-D. The
5.
public keys is converted to PEM format and added to RUGGEDCOM ROX II.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 4.7.3.4
Deleting a Public Key
To delete an unsigned public key, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the public key by typing:
no security crypto public-key key name
Where:
• name is the name of the public key
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 4.7.4
Managing Certificates
The following sections describe how to configure and manage certificates on the device:
•
Section 4.7.4.1, "Viewing a List of Certificates"
•
Section 4.7.4.2, "Viewing the Status of a Certificate"
•
Section 4.7.4.3, "Adding a Certificate"
•
Section 4.7.4.4, "Deleting a Certificate"
172
Key".
RUGGEDCOM ROX II
CLI User Guide
Deleting a Public Key
Advertisement
Table of Contents
Troubleshooting
