Managing Routing Interfaces; Viewing A List Of Routing Interfaces; Configuring A Routing Interface - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
• For Standard OSPF Routes
no routing ospf redistribute [ bgp | rip | connected | static | kernel ]
• For VRF Routes via OSPF
no routing ospf vrf vrf redistribute [ bgp | rip | connected | static | kernel ]
Where:
• vrf is the name of the chosen VRF
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.21.9

Managing Routing Interfaces

The following sections describe how to configure and manage routing interfaces for dynamic OSPF routes:
• Section 5.21.9.1, "Viewing a List of Routing Interfaces"
• Section 5.21.9.2, "Configuring a Routing Interface"
Section 5.21.9.1

Viewing a List of Routing Interfaces

To view a list of routing interfaces for an OSPF network, type:
• For Standard OSPF Routes
show running-config routing ospf interface
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf interface
Where:
• vrf is the name of the chosen VRF
A table or list similar to the following example appears:
ruggedcom# show running-config routing ospf interface | tab
TRANSMIT KEY
IFNAME AUTHENTICATION
ID MD5
---------------------------------------------------------------------------------------------
dummy0 -
fe-cm-1 -
switch.0001 -
Section 5.21.9.2

Configuring a Routing Interface

To configure a routing interface for an OSPF network, do the following:
Managing Routing Interfaces
MINIMAL
DEAD HELLO
COST INTERVAL MULTIPLIER
- 40 -
- 40 -
- 40 -
HELLO
INTERVAL PRIORITY PASSIVE
10 1 true
10 1 true
10 1 true
Chapter 5
Setup and Configuration
RETRANSMIT
INTERVAL DELAY
5 1
5 1
5 1
375