RUGGEDCOM ROX II
CLI User Guide
Section 3.20.9.3
Deleting a Remote Host
To delete a remote host, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the remote host by typing:
no interface serial slot port protocols rawsocket setrawsocket remote-host address remote-port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• address is the IP address for the remote host
• remote-port is the port number for the remote host
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.21
Managing Ethernet Trunk Interfaces
The following sections describe how to configure and manage Ethernet trunk interfaces:
•
Section 3.21.1, "Viewing a List of Ethernet Trunk Interfaces"
•
Section 3.21.2, "Adding an Ethernet Trunk Interface"
•
Section 3.21.3, "Deleting an Ethernet Trunk Interface"
•
Section 3.21.4, "Managing Ethernet Trunk Ports"
Section 3.21.1
Viewing a List of Ethernet Trunk Interfaces
To view a list of Ethernet trunk interfaces, type:
show running-config interface trunk
If trunks have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface trunks
interface
trunks 1
switchport
no alias
no mcast-filtering gmrp
no cos inspect-tos
vlan pvid 1
no vlan gvrp-mode
trunk-ports lm6 1
!
trunk-ports lm6 2
!
no spanning-tree restricted-role
no spanning-tree restricted-tcn
Deleting a Remote Host
Chapter 3
Device Management
121