Managing Prefix Lists And Entries - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
time
To view the status of the RIP interfaces configured on the device, type:
show routing status rip interface
If RIP interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status rip interface | tab
NAME NETWORK
--------------------------------------------------------------------------------------
switch.1112
192.168.11.0/24
This list provides the following information:
Parameter
network
type
sub-type
next-hop
metric
from
tag
time
If no dynamic RIP routes have been configured, configure RIP and add routes as needed. For more information
about configuring RIP, refer to
Section 5.20.3

Managing Prefix Lists and Entries

Neighbors can be associated with prefix lists, which allow the RIPs daemon to filter incoming or outgoing routes
based on the allow and deny entries in the prefix list.
The following sections describe how to configure and manage prefix lists and entries for dynamic RIP routes:
• Section 5.20.3.1, "Viewing a List of Prefix Lists"
• Section 5.20.3.2, "Viewing a List of Prefix Entries"
Managing Prefix Lists and Entries
Description
Synopsis: A string
The route update time.
TYPE SUB TYPE
connected interface
Description
Synopsis: A string
The network.
Synopsis: A string
The route type.
Synopsis: A string
The route sub type.
Synopsis: A string
Next hop.
The metric value.
Synopsis: A string
Where this route comes from.
Synopsis: A string
Tag.
Synopsis: A string
The route update time.
Section 5.20.1, "Configuring
NEXT
HOP METRIC FROM
0.0.0.0 1 self
RIP".
Setup and Configuration
TAG TIME
0
Chapter 5
341