RUGGEDCOM ROX II
CLI User Guide
4.
Configure the neighbor settings by configuring the following parameter(s):
Parameter
remote-as { remote-as }
ebgp-multihop { ebgp-multihop }
maximum-prefix { maximum-prefix }
next-hop-self
password { password }
update-source { update-source }
disable-connected-check
soft-reconfiguration
weight { weight }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 5.19.7.3
Configuring the Distribution of Prefix Lists
To configure the distribution of prefix lists for a neighbor in a BGP network, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Apply the desired prefix list the chosen route direction (incoming or outbound) by typing:
routing bgp neighbor address distribute-prefix-list [ in | out ] prefix-list prefix
Where:
• address is the address of the chosen neighbor
• prefix is the chosen BGP prefix list
3.
If necessary, configure an event tracker to track network commands. For more information, refer to
Section 5.19.7.4, "Tracking Commands for BGP
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Configuring the Distribution of Prefix Lists
Description
Synopsis: An integer between 1 and 65535
A BGP neighbor.
Synopsis: An integer between 1 and 255
The maximum hop count. This allows EBGP neighbors not on
directly connected networks.
Synopsis: An integer between 1 and 4294967295
The maximum prefix number accepted from this peer.
Synopsis: typeless
Disables the next hop calculation for this neighbor.
Synopsis: A string 1 to 1024 characters long
Password.
Synopsis: A string 7 to 15 characters long
Source IP address of routing updates.
Synopsis: typeless
Disables connection verification when establishing an eBGP
peering session with a single-hop peer that uses a loopback
interface.
Synopsis: typeless
Per neighbor soft reconfiguration.
The default weight for routes from this neighbor.
Neighbors".
Chapter 5
Setup and Configuration
331