Enabling/Disabling The Netconf Summary Log; Enabling/Disabling The Netconf Trace Log - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
CAUTION!
Configuration hazard – risk of reduced performance. Enabling diagnostic logging will significantly affect
the performance of RUGGEDCOM ROX II. Only enable diagnostic logging when directed by Siemens.
To enable or disable the SNMP log, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the SNMP log by typing the following commands:
Enable
admin logging diagnostics snmp-log enabled
Disable
no admin logging diagnostics snmp-log enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.9.4.3

Enabling/Disabling the NETCONF Summary Log

The NETCONF summary log briefly records NETCONF protocol transactions and, in particular, those which
completed successfully.
CAUTION!
Configuration hazard – risk of reduced performance. Enabling diagnostic logging will significantly affect
the performance of RUGGEDCOM ROX II. Only enable diagnostic logging when directed by Siemens.
To enable or disable the NETCONF Summary log, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the NETCONF Summary log by typing the following commands:
Enable
admin logging diagnostics netconf-summary-log enabled
Disable
no admin logging diagnostics netconf-summary-log enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.9.4.4

Enabling/Disabling the NETCONF Trace Log

The NETCONF trace log details all NETCONF protocol transactions, including successful and failed transactions.
CAUTION!
Configuration hazard – risk of reduced performance. Enabling diagnostic logging will significantly affect
the performance of RUGGEDCOM ROX II. Only enable diagnostic logging when directed by Siemens.
To enable or disable the NETCONF Trace log, do the following:
1. Make sure the CLI is in Configuration mode.
2. Enable or disable the NETCONF Trace log by typing the following commands:
Enabling/Disabling the NETCONF Summary Log
Chapter 3
Device Management
63