Viewing A List Of Traffic Control Rules; Adding A Traffic Control Rule - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
• Section 5.39.6.2, "Adding a Traffic Control Rule"
• Section 5.39.6.3, "Configuring QoS Marking"
• Section 5.39.6.4, "Deleting aTraffic Control Rule"
Section 5.39.6.1

Viewing a List of Traffic Control Rules

To view a list of traffic control rules, type:
show running-config qos traffic-control advanced-configuration tcrules
If rules have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config qos traffic-control advanced-configuration tcrules
qos
traffic-control
advanced-configuration
tcrules rule1
mark-choice set
mark 1
!
source
destination
protocol
source-ports 80
!
!
!
!
If no rules have been configured, add rules as needed. For more information, refer to
Traffic Control Rule".
Section 5.39.6.2

Adding a Traffic Control Rule

To add a new traffic control rule, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the traffic control rule by typing:
qos traffic-control advanced-configuration tcrule name
Where:
• name is the name of the traffic control rule entry.
3. Configure the following parameter(s) as required:
Parameter
{ name }
iptype { iptype }
578
all
all
tcp
Description
Synopsis: A string
A distinct name for this rule.
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
RUGGEDCOM ROX II
CLI User Guide
Section 5.39.6.2, "Adding a
Viewing a List of Traffic Control Rules