Viewing A List Of Virtual Switches; Adding A Virtual Switch - Siemens RUGGEDCOM ROX II User Manual

Chapter 3
Device Management
• Section 3.24.2, "Adding a Virtual Switch"
• Section 3.24.3, "Deleting a Virtual Switch"
• Section 3.24.4, "Managing Virtual Switch Interfaces"
• Section 3.24.5, "Filtering Virtual Switch Traffic"
• Section 3.24.6, "Managing Filtering Rules"
• Section 3.24.7, "Managing In/Out Interfaces"
Section 3.24.1

Viewing a List of Virtual Switches

To view a list of virtual switches, type:
show running-config interface virtualswitch
If virtual switches have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface virtualswitch | tab
IF FORWARD
NAME ENABLED DELAY
-------------------------------------------------------------------------------------------------
vs1 true 15
!
If no virtual switches have been configured, add switches as needed. For more information, refer to
Section 3.24.2, "Adding a Virtual
Section 3.24.2

Adding a Virtual Switch

To add virtual switch, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the virtual switch by typing:
interface virtualswitch name
Where:
• name is the name assigned to the virtual switch
3. Configure the following parameter(s) as required:
Parameter
enabled
retain-ip
146
IP
ADDRESS
ALIAS SRC PROXYARP
- static -
Switch".
IP
ADDRESS
NAME VID SRC
switch.0001
Description
Synopsis: true or false
Default: true
Enables this interface.
Synopsis: true or false
Default: false
RUGGEDCOM ROX II
CLI User Guide
QOS INGRESS MARK
Viewing a List of Virtual Switches