Adding An Snmp Security Model; Deleting An Snmp Security Model - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
MODEL NAME
-----------------------------
v1 oper
v1 guest
v2c oper
v2c admin
v2c guest
v3 admin
!
!
If no SNMP security models have been configured, add security models as needed. For more information, refer to
Section 5.11.8.2, "Adding an SNMP Security
Section 5.11.8.2

Adding an SNMP Security Model

To add an SNMP security model, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the SNMP security model by typing:
admin snmp snmp-security-to-group model name
Where:
• model is the security model
• name is the name of the user
3. Configure the following parameter(s) as required:
Parameter
{ security-model }
{ user-name }
group { group }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.11.8.3

Deleting an SNMP Security Model

To delete an SNMP security model, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the SNMP security model by typing:
no admin snmp snmp-security-to-group model name
Where:
Adding an SNMP Security Model
GROUP
all-rights
all-rights
all-rights
testgroup
all-rights
initial
Description
Synopsis: { v1, v2c, v3 }
The SNMP security model to use: SNMPv1, SNMPv2c, or USM/SNMPv3.
The security name (a ROX user name) for the SNMP group.
Synopsis: A string 1 to 32 characters long
Default: all-rights
The name of the SNMP group.
Model".
Chapter 5
Setup and Configuration
213