Table of Contents
Advertisement
Chapter 3
Device Management
Section 3.23.8
Configuring DDS
To configure DDS for a WAN interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Navigate to interface » wan » {interface} » dds » ddsparams, where {interface} is the WAN interface.
3.
Configure the following parameter(s) as required:
Parameter
mode { mode }
clock { clock }
4.
Configure a PPP or frame relay connection. For more information, refer to
PPP Connection"
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Section 3.23.9
Managing Channels
The following sections describe how to configure and manage channels:
•
Section 3.23.9.1, "Viewing a List of Channels"
•
Section 3.23.9.2, "Adding a Channel"
•
Section 3.23.9.3, "Deleting Channels"
Section 3.23.9.1
Viewing a List of Channels
To view a list of T1 or E1 lines, type:
show running-config interface wan slot port protocol channel
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• protocol is either T1 or E1
If channels have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config interface wan lm2 1 t1 channel
interface
138
or
Section 3.23.13, "Configuring a Frame Relay
Description
Synopsis: { 56k, 64k }
Default: 56k
DDS speed mode (kbps).
Synopsis: { normal, master }
Default: normal
Serial clocking mode: master or normal.
<itemizedlist><listitem>master : provide serial clock signal.</
listitem> <listitem>normal : accept external clock signal.</
listitem></itemizedlist>
Section 3.23.12, "Configuring a
Connection".
RUGGEDCOM ROX II
CLI User Guide
Configuring DDS
Advertisement
Table of Contents
Troubleshooting
