RUGGEDCOM ROX II
CLI User Guide
Where:
• address is the IP subnet address and prefix for the network
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.20.6
Managing Network Interfaces
The following sections describe how to configure and manage interfaces for a RIP network:
•
Section 5.20.6.1, "Viewing a List of Network Interfaces"
•
Section 5.20.6.2, "Adding a Network Interface"
•
Section 5.20.6.3, "Deleting a Network Interface"
Section 5.20.6.1
Viewing a List of Network Interfaces
To view a list of interfaces configured for a RIP network, type:
show running-config routing rip network interface
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing rip network interface
routing rip
network interface switch.4084
!
!
If no interfaces have been configured, add neighbors as needed. For more information, refer to
"Adding a
Neighbor".
Section 5.20.6.2
Adding a Network Interface
To add an interface for a RIP network, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the neighbor by typing:
routing rip network interface name
Where:
• name is the name of the interface
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Managing Network Interfaces
Chapter 5
Setup and Configuration
Section 5.20.7.2,
347