Chapter 5
Setup and Configuration
Section 5.21.5.1
Viewing a List of Areas
To view a list of areas configured for dynamic OSPF routes, type:
• For Standard OSPF Routes
show running-config routing ospf area
• For VRF Routes via OSPF
show running-config routing ospf vrf vrf area
Where:
• vrf is the name of the chosen VRF
If areas have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing ospf area | tab
AREA
NETWORK
--------------------------
0.0.0.0
192.168.12.0/24
!
If no areas have been configured, add areas as needed. For more information, refer to
an
Area".
Section 5.21.5.2
Adding an Area
To add an area for dynamic OSPF routes, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the area by typing:
• For Standard OSPF Routes
routing ospf area id network/prefix
• For VRF Routes via OSPF
routing ospf vrf vrf area id network/prefix
Where:
• vrf is the name of the chosen VRF
• id is the ID for the OSPF area. The ID must be in the format of A.B.C.D.
• network/prefix is the network and prefix for the OSPF area.
3.
Configure the following parameter(s) as required:
Parameter
shortcut { shortcut }
366
Description
Synopsis: { default, disable, enable }
Default: default
Sets the area's shortcutting mode. Options include:
<itemizedlist><listitem>Default: If the Area Border Router (ABR)
has an active backbone connection, the area is not used for
shortcutting and a new bit (S-bit) is not set by the ABR in the
RUGGEDCOM ROX II
CLI User Guide
Section 5.21.5.2, "Adding
Viewing a List of Areas