Viewing A List Of Interfaces; Adding An Interface - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Section 5.17.9.1

Viewing a List of Interfaces

To view a list of interfaces, type:
show running-config security firewall fwconfig firewall fwinterface
Where:
• firewall is the name of the firewall
If interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security firewall fwconfig fwinterface
security
firewall
fwconfig firewall
fwinterface fe-cm-1
zone man
description Interface
!
!
!
!
If no interfaces have been configured, add interfaces as needed. For more information, refer to
"Adding an Interface".
Section 5.17.9.2

Adding an Interface

To configure an interface for a firewall, do the following:
1. Display the list of available interfaces by typing:
show running-config ip
2. Record the name of the chosen interface.
3. Enter Configuration mode by typing:
config
4. Add the interface by typing:
security firewall fwconfig firewall fwinterface name
Where:
• firewall is the name of the firewall
• name is the name of the interface
5. Configure the interface settings by typing the following commands:
Parameter
iptype { iptype }
278
Description
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Internet protocol type - use both when no addresses are used,
otherwise define IPv4 and IPv6 rules for each type of addresses
used.
RUGGEDCOM ROX II
CLI User Guide
Section 5.17.9.2,
Viewing a List of Interfaces