Viewing A List Of Traffic Control Classes; Adding A Traffic Control Class - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
The following sections describe how to configure and manage traffic control classes:
• Section 5.39.4.1, "Viewing a List of Traffic Control Classes"
• Section 5.39.4.2, "Adding a Traffic Control Class"
• Section 5.39.4.3, "Deleting a Traffic Control Class"
Section 5.39.4.1

Viewing a List of Traffic Control Classes

To view a list of traffic control classes, type:
show running-config qos traffic-control advanced-configuration tcclasses
If classes have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config qos traffic-control advanced-configuration tcclasses
qos
traffic-control
advanced-configuration
tcclasses TCP
interface
mark
min-bandwidth full/2
max-bandwidth full
priority
!
!
!
!
If no classes have been configured, add classes as needed. For more information, refer to
"Adding a Traffic Control
Section 5.39.4.2

Adding a Traffic Control Class

To add a new traffic control class, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the static MAC address by typing:
qos traffic-control advanced-configuration tcclasses name
Where:
• name is the name of the traffic control class entry
3. Configure the following parameter(s) as required:
Parameter
{ name }
iptype { iptype }
Viewing a List of Traffic Control Classes
te1-2-1c01ppp
1
1
Class".
Description
Synopsis: A string
The name for this TC class entry.
Synopsis: { ipv4, ipv6, ipv4ipv6 }
Default: ipv4
Chapter 5
Setup and Configuration
Section 5.39.4.2,
573