Adding A Serial Port Protocol; Configuring The Dnp Protocol - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Section 3.20.3

Adding a Serial Port Protocol

To add a serial port protocol, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the protocol by typing:
interface serial slot port protocols protocol
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
• protocol is the protocol type. Options include dnp, tcpmodbus and rawsocket.
3. Configure the protocol.
• For information about configuring a DNP protocol, refer to
• For information about configuring a Modbus TCP protocol, refer to
Modbus TCP
• For information about configuring a raw socket protocol, refer to
Socket Protocol".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 3.20.4

Configuring the DNP Protocol

To configure the DNP protocol for a serial port, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to interface » serial » {interface} » protocols » dnp » setdnp, where {interface} is the serial port.
2.
3. Configure the following parameter(s) as required:
Parameter
address-learning { address-learning }
aging-timer { aging-timer }
max-connection { max-connection }
4. Add a Device Address table. For more information about adding Device Address tables, refer to
Section 3.20.8.2, "Adding a Device Address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
Adding a Serial Port Protocol
Protocol".
Description
Synopsis: A string 1 to 15 characters long
The interface to learn the RTU address from.
Synopsis: An integer between 60 and 10800
Default: 1000
The length of time a learned DNP device in the Device Address Table may go without
any DNP communication before it is removed from the table.
Synopsis: An integer between 1 and 32
Default: 1
The maximum number of incoming DNP connections.
Section 3.20.4, "Configuring the DNP
Section 3.20.6, "Configuring the Raw
Table".
Device Management
Section 3.20.5, "Configuring the
Chapter 3
Protocol".
115