Adding A Static Vrf Route - Siemens RUGGEDCOM ROX II User Manual

Cli
Hide thumbs Also See for RUGGEDCOM ROX II:
Table of Contents

Advertisement

RUGGEDCOM ROX II
CLI User Guide
Where:
• vrf is the chosen VRF instance
If routes have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing vrf VRF1 ipv4 | tab
NETWORK
-------------------------------------------------------------------------------
192.168.10.0/24
!
If no static routes have been configured, add routes as needed. For more information, refer to
"Adding a Static VRF
Section 5.22.13.2

Adding a Static VRF Route

To add an IPv4 static route for a VRF instance, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the static VRF route by typing:
routing vrf vrf ipv4 route subnet
Where:
• vrf is the chosen VRF instance
• subnet is the subnet (network/prefix) of the static route
3.
If the device has a Layer 3 switch installed, configure the following parameter(s) as required:
NOTE
Only TCP and UDP traffic flows will be accelerated by the IP/Layer 3 switch fabric. Non-IP packet
types, such as ICMP and IGMP, will not be accelerated.
Parameter
hw-accelerate
4.
If necessary, configure a black hole connection for the static route. For more information, refer to
Section 5.22.13.3, "Configuring a Black Hole Connection for a Static VRF
5.
If necessary, add gateways for the static route. For more information, refer to
Gateway for a Static VRF
6.
If necessary, add interfaces for the static route. For more information, refer to
Gateway for a Static VRF
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
7.
Adding a Static VRF Route
HW
DISTANCE
ACCELERATE
-
-
Route".
Route".
Route".
GW
DISTANCE
INTERFACE
1.9.5.1
-
Description
Synopsis: typeless
If the static unicast route can be hardware accelerated,
this option will be available. For a static unicast route to be
accelerated, the ingress and egress interfaces must be switched.
Setup and Configuration
DISTANCE
Section 5.22.13.2,
Route".
Section 5.22.14.2, "Adding a
Section 5.22.15.2, "Adding a
Chapter 5
399

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx1500Rx1512Rx1501Rx1510Rx1511

Table of Contents