Ip Address Assignment - Siemens SIMATIC NET RUGGEDCOM MX5000RE Equipment Manual

Device Management
4.2 IP address assignment
The management port is a 10/100Base-TX copper Ethernet port with an RJ45
connector. The following is the pin-out for the management port:
8
Figure 4.2
Communication Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM MX5000RE console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM MX5000RE is
https://192.168.0.2.
For more information about available ports, refer to "Communication
ports" (Page 41).
Note
Single-mode fiber ports only support Ultra Physical Contact (UPC) cable connectors.
4.2

IP address assignment

An IP address must be assigned to the device to access the command line and Web
interfaces.
By default, the device is assigned the following IP addresses:
MGMT
All other Ethernet ports
You can change the default IP addresses using the one of the following methods:
•
48
1
RJ45 Management Port
Port
192.168.1.2/24
192.168.0.2/24
Connect the device to a DHCP server
When the device is configured to retrieve an IP address from a DHCP server, an IP
address is assigned automatically.
For more information, refer to the
[https://support.industry.siemens.com/cs/ww/en/ps/21322/man]
the installed software release.
Pin Name
1 TX+
2 TX-
3 RX+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 RX-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
Default IP address/mask
"RUGGEDCOM ROX Configuration Manuals"
Equipment Manual, 11/2023, C79000-G8976-1060-17
Description
Transmit Data+
Transmit Data-
Receive Data+
Receive Data-
associated with
RUGGEDCOM MX5000RE