RUGGEDCOM ROX II
CLI User Guide
1.
Make sure the CLI is in Configuration mode.
2.
Add the gateway address by typing:
routing ipv4 route subnet dev interface
Where:
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
3.
Configure the following parameter(s) as required:
Parameter
distance { distance }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.23.7.4
Deleting an Interface for an IPv4 Static Route
To delete an interface for an IPv4 static route, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the gateway address by typing:
no routing ipv4 route subnet dev interface
Where:
• subnet is the subnet (network/prefix) of the static route
• interface is the name of the interface for the static route
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.24
Managing Static Multicast Routing
The following sections describe how to configure and manage static multicast routing:
•
Section 5.24.1, "Enabling/Disabling Static Multicast Routing"
•
Section 5.24.2, "Managing Static Multicast Groups"
•
Section 5.24.3, "Managing Out-Interfaces"
Section 5.24.1
Enabling/Disabling Static Multicast Routing
To enable or disable static multicast routing, do the following:
1.
Make sure the CLI is in Configuration mode.
Deleting an Interface for an IPv4 Static Route
Description
Synopsis: An integer between 1 and 255
The distance for the static route.
Chapter 5
Setup and Configuration
409