Viewing A List Of Prefix Entries; Adding A Prefix List - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
list-permit-lan-22
list-withdraw-lan-11
!
If no prefix lists have been configured, add lists as needed. For more information, refer to
"Adding a Prefix List".
Section 5.19.5.2

Viewing a List of Prefix Entries

To view a list of entries for dynamic BGP, OSPF, or BGP prefix lists, type:
routing bgp filter prefix-list name entry
Where:
• name is the name of the prefix list
If entries have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing bgp filter prefix-list test entry | tab
SEQ ACTION SUBNET
---------------------------------------------
5 permit 192.168.40.0/24
6 deny 192.168.5.21/32
!
!
If no entries have been configured, add entries as needed. For more information, refer to
"Adding a Prefix Entry".
Section 5.19.5.3

Adding a Prefix List

To add a prefix list for dynamic BGP routes, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the list by typing:
routing bgp filter prefix-list name
Where:
• name is the name of the prefix list
3. Configure the following parameter(s) as required:
Parameter
description { description }
4. Add prefix entries as needed. For more information, refer to
Viewing a List of Prefix Entries
-
100 permit
-
100 permit
200 permit
LE GE
32 -
- -
192.168.33.0/24 - -
192.168.33.0/24 - -
192.168.33.0/24 32 -
Description
Synopsis: A string 1 to 1024 characters long
The description of the prefix list.
Section 5.19.5.4, "Adding a Prefix
Chapter 5
Setup and Configuration
Section 5.19.5.3,
Section 5.19.5.4,
Entry".
325