Table of Contents
Advertisement
Chapter 3
Device Management
File transfer phase complete.
Starting download of packages...
---- Package Download Phase ----
progress: 100%
Download phase complete.
Installing packages...
---- Package Install phase ----
progress: 100%
Package installation complete.
Upgrade to partition 2 completed successfully.
A reboot is required to run the upgraded partition.
5.
If the software upgrade is successful, reboot the device or decline the software upgrade. For more
information, refer to
Upgrade".
Section 3.11.4
Stopping/Declining a Software Upgrade
To stop/decline a recent software upgrade and revert back to the previously installed version, do the following:
IMPORTANT!
A software upgrade can only be declined before the device is rebooted. If the software upgrade has
already been activated following a reboot, the previous software version installed on the other partition
can be activated. For more information, refer to
1.
Make sure the CLI is in Configuration mode.
2.
Rollback the software version by typing:
admin software-upgrade decline-upgrade
Section 3.11.5
Downgrading the RUGGEDCOM ROX II Software
The RUGGEDCOM ROX II software can be downgraded to a previous release at any time.
The following sections describe the various methods for downgrading the RUGGEDCOM ROX II software:
•
Section 3.11.5.1, "Rolling Back a Software Upgrade"
•
Section 3.11.5.2, "Downgrading Using ROXflash"
Section 3.11.5.1
Rolling Back a Software Upgrade
To activate a previous version of the RUGGEDCOM ROX II software stored on the inactive partition, do the
following:
1.
Make sure the CLI is in Configuration mode.
76
Section 3.5, "Rebooting the Device"
or
Section 3.11.4, "Stopping/Declining a Software
Section 3.11.5.1, "Rolling Back a Software
Stopping/Declining a Software Upgrade
RUGGEDCOM ROX II
CLI User Guide
Upgrade".
Advertisement
Table of Contents
Troubleshooting
