Viewing The Status Of Dynamic Ospf Routes - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
external { external }
inter-area { inter-area }
intra-area { intra-area }
3. Configure prefix list filters. For more information, refer to
4. Configure areas. For more information, refer to
5. Configure route map filters. For more information, refer to
6. Configure redistribution metrics. For more information, refer to
Metric".
7. Configure interfaces. For more information, refer to
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
8.
Section 5.21.3

Viewing the Status of Dynamic OSPF Routes

To view the status of the dynamic OSPF routes configured on the device, type:
show routing status ospf route network
If OSPF routes have been configured, a table or list similar to the following example appears:
ruggedcom# show routing status ospf route network | tab
ID DISCARD
---------------------------------------------------------------------------------
192.168.1.0/24 no
192.168.2.0/24 no
This list provides the following information:
Parameter
id
discard
inter-area
cost
area
Viewing the Status of Dynamic OSPF Routes
Description
Synopsis: An integer between 1 and 255
The administrative distance for external routes.
Synopsis: An integer between 1 and 255
The administrative distance for inter-area routes.
Synopsis: An integer between 1 and 255
The administrative distance for intra-area routes.
INTER AREA COST AREA
intra area 10 0.0.0.0
intra area 10 0.0.0.0
Description
Synopsis: A string
Network Prefix.
Synopsis: A string
This entry is discarded entry.
Synopsis: A string
Is path type inter area.
Synopsis: A string
Cost.
Synopsis: A string
Area.
Section 5.21.4.3, "Adding a Prefix
Section 5.21.5.2, "Adding an
Section 5.21.6.3, "Adding a Route Map
Section 5.21.8.2, "Adding a Redistribution
Section 5.21.9.2, "Configuring a Routing
HOW
directly attached to fe-1-2
directly attached to fe-1-4
Setup and Configuration
List".
Area".
Filter".
Interface".
Chapter 5
359