Table of Contents
Advertisement
Chapter 3
Device Management
• profile is the profile configured for the module
Section 3.22.9
Running AT Commands
To issue AT (Hayes) commands to the cellular modem, type:
interfaces cellmodem at command command
Where:
• command is the AT command
Section 3.22.10
Connecting as a PPP Client
To connect or disconnect from a cellular network as a PPP client, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Make sure the cellular modem interface has been configured. For more information, refer to
"Configuring a Cellular Modem
3.
Make sure an appropriate cellular modem profile has been configured. For more information, refer to
Section 5.13, "Managing Cellular Modem
4.
Make sure an account has been activated with a service provider for the modem type (e.g. HSPA+, Edge or
CDMA).
5.
Make sure antennas are properly connected to the device before initiating the connection. For more
information, refer to the RUGGEDCOM RX1500 Installation Guide.
6.
For HSPA+ and Edge modems, insert a SIM card into the cellular modem module.
7.
For CDMA modems, activate the modem either manually or over-the-air. For more information, refer to
Section 3.22.7, "Activating a Cellular Modem
8.
Verify the network status for the appropriate cellular modem type. For more information, refer to:
•
Section 3.22.4, "Viewing the HSPA Network Status for Cellular Modems"
•
Section 3.22.5, "Viewing the CDMA Network Status for Cellular Modems"
9.
Select the cellular modem profile to use when connecting to the wireless network by typing:
interface cellmodem slot port [ hspa | edge | cdma ] ppp-client connect-to profile
Where:
• slot is the name of the module location.
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module.
• profile is the cellular modem profile.
10. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
132
Interface".
Profiles".
Account".
RUGGEDCOM ROX II
CLI User Guide
Section 3.22.6,
Running AT Commands
Advertisement
Table of Contents
Troubleshooting
